Non-metallic fabric compensator: the compensation of non-metallic fiber textile fabrics, cotton insulation and metal structures and other components, which by a flexible deformation of the fabric to absorb axial displacement of the line to be compensated lateral displacement or axial displacement of a small amount of a combination of displacement, but also has the ability to compensate for angular displacement. Due to the materials used for the fluorine plastic, silicone, etc., so the product has no thrust bearing simplify design, corrosion resistance, high temperature, noise damping characteristics, is used for hot air pipes and smoke pipes and other environments. During installation, receivership or directly welded pipe, or through the flange and the pipe. The type compensator rod is mainly rigid support during transport, or as a product of pre-deformation adjustment, it is not a load-bearing member. Non-metallic fabric compensator Installation Notes: Install non-metallic compensation should be strictly in accordance with the project piping construction drawings. Installation site and nonmetallic piping connected compensation must locate the relevant technical information and guidance, the installation does not allow non-metallic compensator deformation force adjust the position of the piping installation error. Installation should pay attention to the protection of non-metallic ring bands, to prevent sharp scratches. Must sign non-metallic compensator flow direction is consistent with the medium flow installation. Prohibit the use of transport trolley, lifting the rod limit. After installation, removal of the retaining nut transport, limit rods.